Revision history [back]
Server 2012 R2 Not Capturing Monitor-Session Packets
Hi All,
I've configured a monitor session on a Cisco NCS5501, that is dumping the mirrored traffic to a HP Proliant G8 running Server 2012 R2 on NIC #2.
I can blatantly see that the monitor session is sending traffic to NIC 2 on the server, but WireShark doesn't pick up any incoming traffic,
I've tried installing 3.0.1 & 2.6.8 - same behavior... I have Wireshark running at a remote site on a laptop (same monitor session configuration, and that is not having any issues capturing the traffic.
Any thoughts?
Port traffic stats: GigabitEthernet0/0/0/22 is up, line protocol is up Interface state transitions: 3 Hardware is GigabitEthernet, address is 00bc.602e.7458 (bia 00bc.602e.7458) Description: ***WIRESHARK INTERFACE; HP PROLIANT - NIC2*** Layer 2 Transport Mode MTU 1514 bytes, BW 1000000 Kbit (Max: 1000000 Kbit) reliability 255/255, txload 0/255, rxload 0/255 Encapsulation ARPA, Full-duplex, 1000Mb/s, TFD, link type is force-up output flow control is off, input flow control is off Carrier delay (up) is 10 msec loopback set (Internal), Last link flapped 00:53:58 Last input never, output 00:00:00 Last clearing of "show interface" counters never 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 10000 bits/sec, 18 packets/sec 0 packets input, 0 bytes, 0 total input drops 0 drops for unrecognized upper-level protocol Received 0 broadcast packets, 0 multicast packets 0 runts, 0 giants, 0 throttles, 0 parity 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 60945 packets output, 4525868 bytes, 0 total output drops Output 2 broadcast packets, 81 multicast packets 0 output errors, 0 underruns, 0 applique, 0 resets 0 output buffer failures, 0 output buffers swapped out 3 carrier transitions
Server 2012 R2 Not Capturing Monitor-Session Packets
Hi All,
I've configured a monitor session on a Cisco NCS5501, that is dumping the mirrored traffic to a HP Proliant G8 running Server 2012 R2 on NIC #2.
I can blatantly see that the monitor session is sending traffic to NIC 2 on the server, but WireShark doesn't pick up any incoming traffic,
I've tried installing 3.0.1 & 2.6.8 - same behavior... I have Wireshark running at a remote site on a laptop (same monitor session configuration, and that is not having any issues capturing the traffic.
Any thoughts?