Revision history [back]
How can I enable Monitor mode within Win10 OS
Hello All,
I am using the wireshark with Npcap to capture the Air packet with radio-tag. With the same wireless device, I can capture the air packet within Win7 but not in Win10.
I try the following,
- Make sure there is no older wpcap.dll and packet.all before installing the npacp and wireshark.
- Using administrator privilege to install both application.
- Using Wlanhelper.exe to setup the mode
- check the support raw 802.11 traffic (and monitor mode) for wireless adapters when installing the npcap
- From Wlanhelper, the wireless interface only support Managed mode in Win10.
However, result in Win10 is always not satisfied.
Would it be possible to help how I can start for trouble shooting?
PS: here is the info I have.
Npcap: 0.996
Wireshark: 3.02
WNIC:
DWA-192, HW:A1
Version, 1030 25 701 2017
Chip, Realtek RTL8814AU
Win10:
64bit
Ver 1709 build 16277.1087
Result Not support monitor mode
Win7:
32bit
Ver 6.1 build 7601
Result: Support Monitor mode
Sincerely,
How can I enable Monitor mode within Win10 OS
Hello All,
I am using the wireshark with Npcap to capture the Air packet with radio-tag. With the same wireless device, I can capture the air packet within Win7 but not in Win10.
I try the following,
- following,
1. Make sure there is no older wpcap.dll and packet.all before installing the npacp and
wireshark. - wireshark.
2. Using administrator privilege to install both
application. - application.
3. Using Wlanhelper.exe to setup the
mode - mode
4. check the
supportupport raw 802.11 traffic (and monitor mode) for wireless adapters when installing the npcap -
However, result in Win10 is always not satisfied. 5.
From Wlanhelper, the wireless interface only support Managed mode in Win10.
However, result in Win10 is always not satisfied.
Would it be possible to help how I can start for trouble shooting?
Ver 1709 build 16277.1087
Result Not support monitor mode
Sincerely,