Trying to setup filter for a specific IP address
Trying to do a just a basic filter and when I enter or add it the display remains highlighted in red Basically want to monitor a specific IP address. In older version I just went to toolbar, capture , options, and use "Host 172.16.10.202". Cannot see what has changed and why it would not accept.
Comments
Have you selected an interface, and can you capture from it without a capture filter? The reason to check is that access to the interface is needed to determine the link layer type to properly interpret the capture filter expression.
Thank you for commenting! I had some help with another employee and found out that I was not running in administrator mode so it was not showing my Ethernet ports. Once we restarted in administrator mode I was able to find Ethernet port. I see that it no longer accepts Host 172.16.10.202 so I used "ip.addr == 172.16.10.202". Only see the traffic in on direction though. Now need to find out how to get both traffic to and from an IP address.
I was not running in administrator mode so it was not showing my Ethernet ports. Once we restarted in administrator mode I was able to find Ethernet port. I see that it no longer accepts Host 172.16.10.202 so I used "ip.addr == 172.16.10.202". Just need to find out how to get traffic in both directions.