Decoding SAToP packet with timing
according to the display filter reference, it should be possible to decode satop packets in wireshark, however i have been unable to do so. thus far I have only been able to attempt a manual decoding of the raw packet in hex. I am hoping to show that timing has been inserted. Is there any "trick" to displaying this type of information? thanks for any insight.
Comments
Sample capture attached to 3903: Added: CESoPSN and SAToP over IP+UDP
Are you trying to decode the payload field or just not even getting the control word decode?
Did you set port(s) for SAToP protocol preferences or via "Decode As..." ?
decoding the payload field would be most advantageous as i am trying to determine if timing for adaptive clock recovery is being properly passed across a satop w/udp circuit emulation. i am using decode as... and am able to see control word information, 25% are listed as CW:Bad due to packet malformation. i am investigating that thread, but cannot determine if those packets are those with timing inserted or ortherwise. perhaps payload decoding might assist further, is that possible?
Probably the question is, are you expecting a RTP header in there, because currently that's not supported.
after digging around more thoroughly into satop and how timing works in the payload, it makes sense that i would need RTP decoding. thanks for the help in pointing me in the right direction.
If you could provide a sample capture file we could build that support into Wireshark.